Above is a the wired breadboard used to control and power the motors. The only problem is that to power the servos I must use a 9V battery. Also the servo motors rely on a very high electricity ampere rate, for example once the voltage in the battery falls to approximately 7V it becomes to weak to power the servos. As this is happening when only four servo motors are connected, the battery will not last, if at all when asked to power twelve. So to replace the battery I am going to buy a Regulated AC Adaptor to eradicate this minor problem and give me a constant current rate to the servo motors.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment